Aiwa XR-M1000 Manual de usuario Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
SETTING THE SLEEP TIM
I
1 Press CLOCK/TIMER once, then press ENTER
within 6 seconds.
IHiSi
UVE
/m^ ■' i i
^ ■' ‘ -C? u
2 Turn MULTI JOG to designate the hour, then press
ENTER.
The hour stops flashing and the minute starts flashing.
3 Turn MULTI JOG to designate the minute, then
press ENTER.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To switch to the 24-hour standard
Press the CLOCK/TIMER and then press MULTI JOG within 6
seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
> CLOCK on the remote control is also available instead of CLOCK/
TIMER.
nSET on the remote control is also available instead of ENTER.
> or ►► on the remote control is also available instead of MULTI
JOG.
ft
111
N
<
3
o
111
(L
<
DC
a
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP.
“SLEEP” appears.
I
2 Within 4 seconds, press ◄◄ or ►► to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
iMiliill
■dM
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer [|
Press SLEEP twice so that “SLEEP” on the display disappears.
ENGLISH 13
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Comentarios a estos manuales

Sin comentarios